Tune UP your mazda RX8 - best deal kit
Mazda RX8 Eibach pro kit suspension upgrade

License plate LED lights

September 29, 2011

This DIY shows how to replace the license lights.

For this operation you require these 2 tools:
- new 194 bulbs standard or LED
- Flat Head Screw Driver

LED light swap for mazda rx8

This mode takes only 5 minutes to do. You need to take your flat head screw driver and position is on the end of the lens as shown in picture 1. You then need to pry it off gently. It should pop right out and make sure you catch it because it has a tendency to fly down. The bulb is then visible and you will want to put it out and replace it with you new bulb.

You can choose this type of lights (not LED): http://autolumination.com/194.htm scroll down the page until you see on the right side of the page 194 (Super White) Xeon. It’s about $1.50 each.
You can also use this type of lights to replace all the interior lights of your mazda RX-8.

LED license plate for mazda rx8

You could also use a 3D setup like here:
http://www.rx8shop.com/index.php/113-Lights/204-Rx8-3rd-Brake-Light-Assembly/flypage.tpl

Enjoy your new rear license LED’s.

Information from rx8club.com

RX-8 vs BMW E30 M3 on the track

September 12, 2011

Mazda RX-8 with stock 232 HP engine. Modifications are slightly better Progress springs, Koni shocks, gutted catalytic converter, B&B muffler, Hawk Brake HP+ front pads, Hawk HPS rear pads, and Hoosier R6 tires on stock rims

RX8 R3: Night scens in HD

September 2, 2011

City and night scenes of a mazda R3 2011 model