License plate LED lights
September 29, 2011 · Print This Article
This DIY shows how to replace the license lights.
For this operation you require these 2 tools:
- new 194 bulbs standard or LED
- Flat Head Screw Driver
This mode takes only 5 minutes to do. You need to take your flat head screw driver and position is on the end of the lens as shown in picture 1. You then need to pry it off gently. It should pop right out and make sure you catch it because it has a tendency to fly down. The bulb is then visible and you will want to put it out and replace it with you new bulb.
You can choose this type of lights (not LED): http://autolumination.com/194.htm scroll down the page until you see on the right side of the page 194 (Super White) Xeon. It’s about $1.50 each.
You can also use this type of lights to replace all the interior lights of your mazda RX-8.
You could also use a 3D setup like here:
http://www.rx8shop.com/index.php/113-Lights/204-Rx8-3rd-Brake-Light-Assembly/flypage.tpl
Enjoy your new rear license LED’s.
Information from rx8club.com
Comments
Got something to say?